Recent ads
No ad viewed yet.
Who's new
- tgee112
- sedatebeard
- Fritske1978
- catalystwallet
- muttoneveryday
Who's online
There are currently 0 users online.
Poll
Do you think this site needs either a FAQ or Sticky Posts thread for questions asked?
Yes. It would be quicker to resolve a problem.
96%
No. I like to search for hours on end or just post up a thread without knowing its been answered before.
4%
Total votes: 310
Comments
Looks nice, shame I have a
Looks nice, shame I have a F70 Is 8mm strong enough for off-road?
Strong enough?
It's probabaly stronger than the sections its going to be fastened to!
Maybe, I ment for taking hits
Maybe, I ment for taking hits off rocks ect, not strong enough to support the weight of the box.
Strong enough
Hi Stalin
the plate is very strong with the fold in the rear and should be an improvement over the original crossmember which isn't actually a box section but a flat plate and top hat section spot welded together both of which are around 2mm thick. It doesn't support the gearbox/transfer case but simply braces the chassis against twisting forces where the torsion bars are anchored, I assume it unbolts to ease access to the tosion bar anchors and transfer case.
Best regards
Dave
www.bloodredoffroad.com
Ah right, I thought it
Ah right, I thought it supported the box like it does on my F70. Looks a very nice bit of fabrication though
So how much then?
So how much then?
Daihatsu Fourtrak Fieldman TDL