Engine Swap EF-SE (Mira LE-L250V with ECC A32) in Cuore

Forum: 

hi all i swapped the cuore ED-10 with EF_SE engine and my electrician couldn't wire the accessories with the ECU he just Plugged the engine harness in the ECU leaving all the accessories. Now i have been trying to wire the rest of stuff i managed to find the headlight, Blower heater, Idle switch, STA signal, Fault lamp,etc etc and just now i am done with all the errors like 51,54,13,44. Now vehicle is not turning on the fault lamp but i couldn't hookup the ACSW as AC relay wouldn't turn on. 2ndly i am looking for the DLC connections in case any body has any idea regarding this model or engine or has any info.
this is the error code list that i worked with http://www.daihatsuhijet.co.uk/wp-content/uploads/2013/11/s200-atrai-extol-cargo-engine-warning-light-flash-codes.jpg
http://www.daihatsuhijet.co.uk/wp-content/uploads/2013/11/s200-Atrai-Extol-Cargo-Engine-ecu-wiring-diagram-1024x840.jpg
this was the wiring diagram that i started working with most of the connections seems to be same except few that i found out i.e. Pin 11 is not selection its STA, pin 40 is not idle its 35 and i am not sure that MAG Clutch pin is 7. ACSW seems to be same as it gave me error code 44 when i removed a resistor depicting temperature sensor from pin 59-52. pin 27 that is Mentioned as STA has 5 volts more like a sensor input pin. SIO pin (12) is at 12V with very low current of merely 4mA can a signal pin be that high as it is?? i assumed it to be as M/T selection Pin as A/T selection Pin is also at 12V.