i took the plastic wheel arches off today

Forum: 

lots of rust ive had to chop it right back ive bought some thin steel to weld on the inners rear arches but id rather not do the arches in bits of steel id rather replace whole arch.
anyone know where i can buy replacement arches from to weld straight in place.
thanks

anyone any help on where to

anyone any help on where to find arches from
i welded the ns rears today but its hard work with
out them it would be nice to just weld new ones in place.

Everyman is the architect of his own future.

Onobtainable as no one made

Onobtainable as no one made them for Fourtraks, to replace then you had to replace the entire 1/4 panel which was obtainable from Daihatsu only.

Two options, make a template and form your own in steel, or try aftermarket suppliers for plastic ones which are similar, and modify them.

er dont fancy doing whole 1/4

er dont fancy doing whole 1/4 panel ill finish of with the steel ive got.
ill look into the plastic ones though just in case they rot through again.
thanks.

Everyman is the architect of his own future.

One idea, bye plastic

One idea, bye plastic Landrover Spatz / wheel arches off e-bay, then cut your wheel arches to fit them.
How prity should this be? Are we talking shiny head turning beautiful, beatten up green lane car or slightly tatty but not ugly everyday vehicle?

Any veiws expresed in this thread by me are purely from my own experience, and (sometimes) falible memory. Hope my comments help, but please don't take them as gospel.

3 days to sort the rust out

3 days to sort the rust out on this motor.
its one of the only problems ive found on this fourtak but its a major one.
mine a 91 jreg f75 did they sort this problem of rusting at the arches out in later models?

Everyman is the architect of his own future.