A road crash in which four children died when a Land Rover plunged into a river was an "avoidable tragedy", a court heard.
Mechanic Nigel Gresham is accused of four counts of causing death by dangerous driving following the accident which left four of his seven children dead.
I am trying to find out what is worng with my a mates M Reg Daihatsu Sportrak 1.6 (HD Engine).
As this is pre 2000 I am 99% sure this will not have the standard 16pin diag socket, but will use the older blink code system, by sorting out a few pins in the diag socket.
My 94 4Trak TDS has two eyes at the front & nowt at the rear! -- Sure there are two holes on the support rails for the towing bracket but you cant attach a rigid towing bar to them as the surround is too thick.
Ive just changed engine oil in my 1999 Fourtrack 2.8 TDX - a simple job, but I mistakenly undid wrong drain plug and let some oil out of front transmission (at least I think thats what it is - big drain plug at bottom middle of engine, cut out in sump guards ect to allow access) . I cant obvioulsy see where I top it up - can anyone advise?? { Think I'll stick to sending it to the garage in future - first time ive attempted this simple job on a Fourtrack and, as they say, a little knowledge is a dangerous thing!)
hi i have a rocky 1986 diesel 2.8 and i would like to know if doing a spring over axle conversion to rase it up its safe with the same leaf springs or will i have to purchase new leaf springs.
hy my name is angel and am currently leaving in panama central america and i woul like to buy parts that place call milners offroad and i would like to know if its a save place to buy things from and would it deliver parts to my country
After being without my 4trak for three weeks and being let down by my mechanic a friend and I changed my clutch today. It took us five and a half hours to do the job. We took the engine out and did it that way round. Everything works fine now, touch wood.
I have just fitted rear springs and shockers to my 96 sporty.According to w shop manual torque setting is 57 point summat ftlbs.Having spent last 50 years around heavy plant and HGVs this doesnt seem very tight.Am I just being unnecessarily biased towards 30 inch breaker bars and a lenghth of pipe or is this setting correct? Thanks in advance Geoff H
